Circuit safety, steel cage protection, wiring care.
Safety plan based on careful wiring, separation of power and signal lines, and physical protection.
The electronics should stay inside a steel cage for protection.
The cage should allow airflow so heat does not build up.
Battery terminals should be covered to avoid short circuits.
Power wires should be stronger than small signal wires.
Relay and driver modules should be mounted on insulated support.
RS485 terminals should be tightened properly.
Signal wires should be kept away from high-current motor wires.
The setup should stay protected from direct water splash.
A fuse should be added near the power source.
The system should be checked for rust, loose joints, and heat damage.